Table of Contents
Advertisement
5-14-11
Signal Tone Measurement
The Signal Tone output of the UUT may be measured by utilizing the fol-
lowing procedure:
STEP
PROCEDURE
The UUT and the FM/AM-12005 must be programmed to
the same Ch6nnel Number to perform the ST Measure-
ment.
Set the UUT for output on the Voice Channel
programmed for the FM/AM-1200S.
1.
Connect UUT to T/R Connector (11)
2.
Turn MODE Selector Control (39) to "REC".
3.
Using Keyboard (18), enter the desired Voice Channel
Ntlmber or
Mobile Transmit/Cell Site Receive Frequency (For the Transmit
Frequency of the programmed Voice Channel, Ref. Appendix G for
AMPS units or Appendix H for ETACS units).
~~
As an alternative method,
press:~~
Use the
l
~l
~l__j
Key, if necessary, until the VFD displays:
/ I I
I
l!,' l xl
ILIHIHirJI=I
lxlxlxlxl
I I /
4.
Utilize the manual test instructions for the UUT for output of
the ST from the un1t's T/R connector or antenna.
5.
5-8 4
0 7
a.
Turn on UUT transmitter.
b.
Turn on UUT ST.
c.
Program UUT to desired Voice Channel.
~~~
On the FM/AM-1200S front panel,
press:~~~
The VFD indicates:
Advertisement
Table of Contents
