Table of Contents
Advertisement
STEP
PROCEDURE
11 .
r;;l
Press the : __
c_j
key six times or until the VFD indicates:
12.
The cell site (the FM/AM-1200S) begins paging as the VFD shows:
l 1 1r1[0IBIIIL lrl II IN[ II rl I I I I I l l
13.
Turr the mobile unit power on.
The FM/AM-1200S will begin a
mobile unit Registration as the VFD shows:
14.
Continue with a Manual Cell -to-Mobile Call and Auto Handoff Test
as shewn in 5-14-9, Step 3 and on.
Procedures 5-14-4 and 5-14-6
thru 5-14-7 may also be performed.
5-14-15
Cellular Auto Test Procedure
When the Auto Test is selected, Mobile-to-Cell Call, the Cell-to-Mobile
Call, the measurement of eight transmit power levels for the UUT and
the Handoff Tests will be performed sequentially.
Do not turn
RTD~ON
when utilizing GP!B/RS-232.
To perform the Auto Test, complete the following steps:
STEP
PROCEDURE
1 .
2.
Press:~~~
3.
The FM/AM-1200S will perform these tests and measurements:
5-9 0
07
Mobile-to-Cell Call
SINAD Test (if enabled)
Cell-to-Mobi
1
e Call
Power Level 0 through 7 Measurement
Handoff Test (if enabled)
Supervisory Audio Tone (SAT) Measurement
Signal Tone (ST) Measurement
Advertisement
Table of Contents
