Table of Contents
Advertisement
1
!
STEP
b.
5-66
06
PROCEDURE
Test Format
The "Test Format• VFD displayed is dependent on the
Option installed.
Option 15 (AMPS) or Option 16 (E-
TACS) will display the appropriate screen.
Printout Enable
kllzlll
Any digit key toggles
through selections
is selected, test results may be slowed as the test
set searches for the output device.
If:
is selected,
press~
and proceed to 5-14-3.
RAM Test
When the PWR/OFF/BATT Switch (22) is set to the "PWR" position, a
RAM Test occurs.
Results of this test will output to the printer
output pins of the RS-232 Connector (43).
If the test is success-
ful and a printer is connected to this connector, the message
"RAM OK, PRINTER OK. will print out.
!NOTE!
"PRINT ENABLE. does not have to be programmed for
this output to print.
The Printer Parameters for
the printout are:
BAUD RATE
~
9600
DATA BITS
~
8
SET STOP BITS
~
1
SET PARITY
=
NONE
Advertisement
Table of Contents
