Table of Contents
Advertisement
Data inputs that are out
of
specific range will generally default
to
the
minimum values or initial condition values.
5-12-10 REPLY IDENTIFIER
When the Reply Identifier is activated by the command "RID=ON", the
returned information for data or status requests wi 11 be preceded by the
command mnemonic and an "=" character.
This will continue until
the
command "RID=OFF" is given or the FM/AM-12005/A power is cycled.
This
feature is especially useful
for identifying measured data that is
returned after a time delay, or data returned from a string of
commands.
5-12-11 ALLOWABLE GPIB COMMAND FORMATS
The following list defines the Commands used to control
the
FM/AM-12005/A under GPIB operation.
Qualifiers for each command are
used throughout the following paragraphs and are defined as follows:
An ''=" represents a ''set'' operation for that command.
A
"?"
represents a "get" operation for that command.
A"." represents an "enable" operation for that command.
Data listed under the range column reflects input/output data of the
FM/AM-12005/A.
Data shown in parentheses is input data.
Data not
enclosed in parentheses is out put data.
A dash is used for commands
having no input/output data.
5-27
03
Advertisement
Table of Contents
