IFR FM/AM-1200A Operation Manual page 134

5-11-2 SELECTING TRACKING GENERATOR MODE OF OPERATION
Table 5-4 lists the FM/AM-1200S front
Tracking Generator operation. To use
the following steps:
panel controls applicable to the
the Tracking Generator, perform
STEP
1.
PROCEDURE
Set the FM/AM-1200S front panel controls to the settings listed
in Table 5-4.
2. Connect the input of the unit under test to the DUPLEX Output
Connector (14) of the FM/AM-1200S.
3. Connect the output of the unit under test to the ANTENNA
Connector (34) of the FM/AM-1200S.
/CAUrloN\
MAXIMUM CONTINUOUS INPUT TO THE ANTENNA CONNECTOR
(34) MUST NOT EXCEED 0.25 WATTS.
4. Enter the center frequency of the UUT using the procedure
outlined in paragraph 4-2-1.
5.
Press:
'f;;]i~·
One of the following displays will appear on
the VFD:
l 1 11l l u i P IL l[lxl IHIIIGIHI I I I I I l l
lllllluiPIL IL lxl IL lulwl I I I I I I l l
I l l riRinlciHI IHIIIGIHI I I I I I I l l
I l l riK/I,qlciHI INI[Illl I I I I
I
I I l l
I l l ri K /I,ql c l : -(1 IL lolwl I I I I I I I l l
6.
following orte of these displays will indicate the
currently selected mode of operation. Use the
!.i.
and!;; keys to scroll through the modes until the desired
LI___
selection appears on the VFD.
5-17
05