.
j
'
5-11
TRACKING GENERATOR- OPTION 12 (FM/ AM-12005 ONLY)
FM/AM-1200S CONNECTORS AND
INDICATORS APPLICABLE TO
TRACKING GENERATOR OPERATION:
14
DUPLEX Output Connector
31
CRT Display
34
ANT Connector
37
VFD
Figure 5-4
FM/AM-1200S Front Panel Controls
Applicable to Tracking Generator
Operation
18
Keyboard
22
PWR/OFF/BATT Switch
24
VERTICAL ATTENUATOR
Selector Control
25
HORIZONTAL Sweep
Vernier Control
26
HORIZONTAL Sweep
Selector Control
27
VERT POS Control
28
INT Control
29
FOCUS Control
30
HORIZ POS Control
39
MODE Selector Control
"As req'd"
"Pl~R"
or "BATT"
Any position
except "OFF"
Fully cw
"1 MHz/Div"
"Mid Range"
As req'd
As req'd
"Mid Range"
DU P
Table 5-4
FM/AM-1200S Front Panel Controls Applicable
to Tracking Generator
5-11-1 GENERAL
The Tracking Generator option allows operators to accomplish the tuning
and alignment of radio communications components such as notch
dupl exers, circulators, combiners, isolators, etc.
The device under
test is connected between the swept RF output present at the DUPLEX
Output Connector (14) and the input to the Spectrum Analyzer at the
ANTENNA Connector(34).
5-15f Blank/5-16