IFR FM/AM-1200A Operation Manual page 169

5-13-5 Repeater Simulation Mode
This test may be used to check the operation of a mobile radio unit by
using the FM/AM-1200S to simulate the workings of a repeater to perform
such tests as a "Simple Handshake" or a "Repeater Handoff". For this
test, the FM/AM-1200S must be programmed for several parameters
relating to repeater functions using these steps:
STEP PROCEDURE
1 .
Press:
Iii[!]~~~.
The following display will appear on the VFD:
2.
Press:
~~~
An open programming format for the repeater
simulation will appear on the VFD in the following configuration:
These
programming
bits are:
Border Offset -
(0, 1 or 2
See NOTE Below )
Home Repeater
Number (1-20)
r
Home Repeater
Channel Numbe
( 1-600 with Bord
1-399 with Borde
er Offset 0 or 1,
r Offset 2)
umber (1-20) Free Repeater N
Free Channel Nu mber
( 1-600 with Border Offset 0 or 1,
1-399 with Border Offset 2)
I
A "2" entered as the "Border Offset" bit allows testing
of Trunking radio equipment utilizing the High Trunk-
ing Frequency Band (896 MHz to 935 MHz) in Tests 1, 2
and 3.
3. Place Programming Template 2 over the FM/AM-1200S front panel.
6103003
4.
~ ~
Use
the~ and~
keys to move the cursor to the desired location
on the VFD and enter each digit of the data required.
5-54
08