5-5
GENERATE AMPLIFIER - OPTION 05
5-5-1
GENERAL
The Generate Amplifier is a 30 dB amplifier intended to increase the
output level of a generated signal above the normal maximum level by the
service monitor.
It is not designed to receive any signal directly from
a Unit Under Test (UUT); however, if properly installed, it can be used
to transmit and receive signals ''off the air'', using the antenna.
/CAUTION\
DO NOT TRANSMIT FROM A UUT DIRECTLY INTO THE
GENERATE AMPLIFIER, OR THROUGH AN EXTERNAL
ATTENUATOR.
DAMAGE TO THE GENERATE AMPLIFIER
AND/OR THE SERVICE MONITOR WILL RESULT.
5-5-2
INSTALLATION
Insert the banana plug on the Generate Amplifier into the AUX PWR Jack
on the Front Panel of the Service Monitor and connect the BNC connector
to the T/R Jack (reference Figure 5-l).
For Direct Connection TO UUT:
Connect coax cable between the UUT Test Jack on the Generate Amplifier
and the Microphone Jack or other audio input on the UUT.
For Radio Installation Checkout:
5-2
04
I
WARNING!
THIS TEST MUST BE PERFORMED WITH THE SERVICE
MONITOR AND UUT INSIDE A SHIELDED AREA TO
PREVENT UNRESTRICTED RADIATION OF RF SIGNALS.