Installation And Electrical Connection; Opening The Charging Station Cover; Wall Mounting The Charging Station - Webasto Unite Operating And Installation Instructions

Table of Contents

Advertisement

6
Installation and electrical
connection
ATTENTION
High voltages
Danger of fatal electric shock.
The Webasto Unite must be installed by a qualified elec-
trician.
Charging station installation steps
l Installation and connection of the charging station must
only be carried out by a qualified electrician.
l Make sure that the ground resistance of the installation is
less than 100 ohms.
l Read these instructions before mounting your charging sta-
tion.
l Do not mount your charging station on the ceiling or on a
sloping wall.
l Use the specified wall mounting screws and other accessor-
ies.
l This charging station is classified as indoor and is outdoor
installation compatible.
If the charging station is installed outside a building, the
hardware that is used to connect the cables to the charger
must be compatible with outdoor use, and the charging
station must be mounted accordingly to preserve the char-
ger's IP rate.
6.1

Opening the charging station cover

DANGER
Danger of fatal electric shock.
u
Switch off and secure the power supply to the char-
ging station.
Fig. 2
1.
Remove the cover screws using a Torx T20 security L-
wrench, or with a right-angle screwdriver adapter with a
Torx T20 security bit.
Fig. 3
2.
Open the cover.
5111967A OI-II Webasto Unite

Installation and electrical connection | 6

6.2
Wall mounting the charging
station
Fig. 4
1.
Open the charging station's front cover (See chapter 6.1,
"Opening the charging station cover" on page 9).
US E Sp
Fig. 5
2.
Position the charging station on the wall by using the
mounting template, and then mark the drill positions.
Fig. 6
3.
Locate the marked drill points on the wall, and then drill
the mounting holes, using an impact drill with an 8 mm
drill bit.
4.
Place the dowels into the drill holes.
Fig. 7
5.
Position the unit in line with the inserted dowels, and then
secure it with the security screws (6 x 75) using a Torx T25
Security Screwdriver.
nm en t
l fo r al ig
iri t le ve
90 º
22 6,0 0
tle t
Ca ble ou
65 ,50
le 1/1
Pri nt sca
9 / 37

Advertisement

Table of Contents
loading

Table of Contents