Table of Contents
Advertisement
9 | Setting up charging
Fig. 56
Constant blue (or no LED Indication in power save
mode)
Unplug the charging cable from the charging station.
9.3.2
RFID Authorisation mode
With some configuration variants, you may find RFID cards (1x
master card; 2 x user cards). The master RFID-card is required
for adding or deleting user RFID cards. User RFID cards are re-
quired to start or stop charging sessions.
Fig. 57
9.3.2.1
Adding user RFID cards to a charging station
If you want to switch to RFID authorised mode and to register
user RFID cards to the charging station, you must first tap your
charging station with your master RFID card when the charging
cable is not connected. After doing so, the indication LED will
start to blink blue for 60 seconds. During this period you can
add/delete a given user RFID card. If you do not make any con-
figuration changes within 60 seconds, the charging station will
exit from its configuration mode and will return to its previous
mode. You must repeat these steps for each user RFID card ad-
dition/deletion.
9.3.2.2
Vehicle connecting & charging
Fig. 52
Constant blue (or no LED Indication in power save
mode)
Make sure that your vehicle and the charging station are ready
for charging.
Fig. 53
28 / 37
Constant blue (or no LED Indication in power save
mode)
Insert the charging plug into the vehicle inlet and the charging
station socket outlet.
Fig. 60
Blinks blue
4 sec
Tap the user RFID card on the reader.
Fig. 61
Green glowing
Start charging with a card that has been authorized before.
Fig. 54
Blue glowing
Charging starts and the status indicator LED glows blue.
NOTE
Charging operation requires an authorized card
Charging operation is rejected by the charging station
when you want to start charging with an unauthorized
card.
9.3.2.3
Stop charging
You must only use the following alternative methods to stop
charging. Never attempt to unplug the charging cable from its
charging station before stopping charging, otherwise the lock-
ing mechanism may get damaged.
Method 1
Fig. 63
Constant Blue
You can terminate charging by tapping the RFID card that you
have used to start charging.
Method 2
5111967A OI-II Webasto Unite
Advertisement
Table of Contents
