Shut Off Fuel Supply; Drain Coolant From Cooling System - Kohler LH630-775 Service Manual

Section 9
Disassembly

Shut Off Fuel Supply

Remove Muffler
1. Remove the exhaust system, muffler, and
attaching hardware from the engine.
Remove Starter and Adapter Plate
1. Disconnect the leads attached to the starter
solenoid terminals.
2. Remove the two hex flange screws securing the
starter to the adapter plate. See Figure 9-2.
Figure 9-2. Removing Starter Assembly.
3. Remove the two hex flange screws attaching the
adapter to the crankcase. Note the orientation of
the cutout. The upper screw may also secure a
clamp for the stator leads.
Figure 9-3. Removing the Adapter Plate Screws.
9.2

Drain Coolant from Cooling System

1. Loosen the radiator cap, then loosen the radiator
drain plug and allow the system to drain. Use
a suitable container to catch the coolant. See
Figure 9-4.
Radiator Drain Plug
Drain Plug
Figure 9-4. Radiator Drain Plug.
2. If equipped, remove the coolant drain plugs on
each side of block. Allow any remaining coolant
to drain out. See Figure 9-5. Dispose of the coolant
properly, according to local regulations.
Figure 9-5. Removing Coolant Drain Plugs in Block.