Kohler LH630-775 Service Manual page 118

4. Remove the carburetor, throttle linkage and
governor lever as an assembly. See Figure 9-23.
Figure 9-23. Removing Carburetor from Engine.
5. Remove the carburetor gasket.
6. The carburetor, adapter, throttle linkage, and
governor lever may be separated for individual
component servicing as required. If the linkages
are separated, reattach the bushings to the
linkages to prevent them from being lost.
Remove Oil Sentry™ (If So Equipped)
1. Disconnect the wire lead from the Oil Sentry™
switch, and remove the switch from the breather
cover. See Figure 9-24.
Figure 9-24. Oil Sentry™ Location on Engine.
Remove Breather Cover
1. Remove the four hex flange screws securing the
breather cover to the crankcase. See Figure 9-25.
Figure 9-25. Removing the Breather Cover Screws.
2. Carefully pry under the protruding edge of the
breather cover to separate and remove the cover
from the gasket. See Figure 9-26.
Figure 9-26. Prying Off the Breather Cover.
Do not pry on the sealing surfaces as it could
cause damage resulting in leaks.
3. Remove the breather gasket and fiber filter from
the breather chamber. See Figure 9-27.
Figure 9-27. Removing the Breather Gasket and
Filter.
Section 9
Disassembly
9
9.7