Kohler LH630-775 Service Manual page 175

Figure 11-121. Installing Oil Filter.
4. Remove the oil fill cap from the valve cover. Fill
the crankcase with new oil to the "F" mark on the
dipstick. Refer to "Oil Type" and "Check Oil Level"
on pages 6.1 and 6.2. Check oil level again after
initial running. Always check the level with the
dipstick before adding more oil. Push dipstick in
completely.
5. Reinstall the oil fill cap and tighten securely. See
Figure 11-122.
Figure 11-122. Installing Dipstick and Oil Fill Cap.
Install Coolant
1. Use equal parts of ethylene glycol (antifreeze)
and water only. Distilled or deionized water is
recommended, especially in areas where the
water contains a high mineral content.
Propylene glycol based antifreeze is not
recommended.
2. Fill the cooling system, through the radiator,
with the coolant mix. Allow the coolant to drain
into the lower areas. Fill the overflow reservoir
midway between the "FULL" and "ADD" marks,
then install the radiator and reservoir caps. See
Figures 11-123 and 11-124.
Figure 11-123. Radiator Cap (Install After Filling).
Figure 11-124. Coolant Reservoir with Coolant.
Reconnect Battery and Spark Plug Leads
Connect the leads to the spark plugs. Reconnect the
positive (+) battery lead first, and the negative (-) lead
last when connecting the battery.
Section 11
Reassembly
11
11.33