Kohler LH630-775 Service Manual page 165

Install Carburetor and Adapter
1. If separated, install the breather tube to breather
cover as shown in Figure 11-78.
Figure 11-78. Breather Hose Installed onto
Breather Cover.
2. Install the carburetor gasket on the intake
manifold. See Figure 11-79.
Figure 11-79. Installing Carburetor Gasket on
Intake Manifold.
3. Attach the longer ends of the throttle linkage and
spring to the carburetor (if disconnected
previously), then install the carburetor onto the
intake manifold. Install and torque the two
mounting screws to 6.2-7.3 N·m (55-65 in. lb.).
See Figures 11-80 and 11-81.
Figure 11-80. Torquing Carburetor Mounting
Screws.
Figure 11-81. Torquing Carburetor Mounting Bolts.
4. If the adapter was separated from the carburetor,
install a new gasket and mount the adapter with
the breather hose connection port facing the rear.
Install and torque the mounting screws to
7.3 N·m (65 in. lb.).
Figure 11-82. Installing Carburetor Breather
Adapter.
Section 11
Reassembly
11
11.23