8. Further disassembly for component servicing
may be performed as required.
Remove Air Cleaner Assembly
1. Remove the two screws securing the elbow
adapter and gasket to the carburetor. See
Figure 9-15.
Figure 9-15. Removing Elbow Adapter Mounting
Screws.
2. Remove the two upper valve cover mounting
screws on each side, which also secure the
main mounting bracket for the air cleaner. See
Figure 9-16.
Figure 9-16. Removing Upper Valve Cover
Mounting Bracket Screws.
3. Lift the air cleaner/mounting bracket assembly
off the engine. See Figure 9-17.
Figure 9-17. Removing Air Cleaner From Engine.
Remove Throttle and Choke Controls
1. Remove the four hex flange screws securing the
main control bracket to the cylinder heads. See
Figure 9-18.
Figure 9-18. Removing the Four Screws From Main
Control Bracket.
2. Mark the hole location and disconnect the
governor spring from the governor lever.
Section 9
Disassembly
9
9.5