Kohler LH630-775 Service Manual page 170

Section 11
Reassembly
If the belt tension is low, remove the belt and
relocate a shim from between the pulley halves
to the outside (front). Reinstall the belt and
recheck the tension. Repeat the procedure until
the correct tension is reached. if the shims have
all been moved to the outside, and the belt is still
too loose, replace the belt.
NOTE: Do not assemble the lower pulley with
the belt between the pulley halves, as
pinching of the belt or damage to the
pulley can occur.
When proper tension is obtained, individually
remove each capscrew, apply Loctite
the threads of lower pulley and reinstall. Torque
the four bolts in a criss-cross sequence to
24.3 N·m (215 in. lb.). See Figure 11-100.
Figure 11-100. Torquing Lower Pulley Screws.
9. Mount the RH and LH lower radiator supports
with cross support bracket attached, to the
crankcase, using the four hex flange screws. Snug
the screws only at this time. See Figure 11-101.
Figure 11-101. Mounting Lower Radiator Supports.
11.28
Install Air Cleaner Assembly
1. Install a new elbow adapter gasket onto the
carburetor adapter. See Figure 11-102.
®
No. 242 to
Figure 11-102. Installing Elbow Adapter Gasket.
2. Set the air cleaner/mounting bracket assembly,
with the hose and elbow attached, in position on
the engine. Align all of the mounting holes. Start
and finger tighten each of the mounting screws.
Make sure the fuel line is outside of the main
bracket when installed. See Figures 11-103 and
11-104.
Figure 11-103. Installing Air Cleaner Assembly.