Kohler LH630-775 Service Manual page 128

Remove Governor Cross Shaft
1. Remove the retaining ring and nylon washer
from the governor cross shaft. See Figure 9-64.
Figure 9-64. Removing Governor Shaft Retaining
Ring and Washer.
NOTE: Always use a new retaining ring when
reassembling. Do not reuse the old
retaining ring.
2. Remove the cross shaft and small washer out
through the inside of the crankcase. See Figure
9-65.
Figure 9-65. Removing Governor Cross Shaft.
Remove Flywheel End Oil Seals
1. Remove the flywheel end crankshaft and
camshaft oil seals from the crankcase. See
Figure 9-66.
Figure 9-66. Oil Seals (Flywheel Side and Camshaft).
Section 9
Disassembly
9
9.17