Kohler LH630-775 Service Manual page 103

Section 8
Electrical System and Components
4. Remove the two thru (larger) bolts. See Figure
8-19.
Figure 8-19. Removing Thru Bolts.
5. Remove the commutator end plate assembly,
containing the brush holder, brushes, springs,
and locking caps. Remove the thrust washer
from inside the commutator end. See Figure 8-20.
Figure 8-20. Removing Commutator End Plate
Assembly.
6. Remove the frame from the armature and drive
end cap. See Figure 8-21.
Figure 8-21. Starter Frame Removed.
8.14
7. Remove the drive lever pivot bushing and
backing plate from the end cap. See Figure 8-22.
Figure 8-22.
8. Take out the drive lever and pull the armature
out of the drive end cap. See Figure 8-23.
9. Remove the thrust washer from the armature
shaft. See Figure 8-23.
Figure 8-23. Armature and Lever Removed.
10. Push the stop collar down to expose the retaining
ring. See Figure 8-24.