Kohler LH630-775 Service Manual page 161

3. Connect the wire leads to the temperature
warning switch, audible alarm, and/or Oil
Sentry™ switch, as equipped.
Install Stator Assembly
1. Place a small amount of pipe sealant with
Teflon ® (Loctite ® 59241 or equivalent) into the
holes for the two stator mounting screws.
Position the stator assembly onto the mounting
studs so the leads are at the bottom, and directed
out toward the #1 side, in the 3 o'clock position.
Align the mounting holes and install the two hex
flange screws. Torque each screw to 6.2 N·m
(55 in. lb.). See Figure 11-63.
Figure 11-63. Torquing Stator Screws.
Install Starter Adapter
1. Install the starter adapter to the crankcase, so the
cutout is offset down and facing away from the
flywheel side. Install the two mounting screws,
and position the clamp for the stator leads on the
upper screw. See Figure 11-64. Torque the screws
to 15.3 N·m (135 in. lb.).
Figure 11-64. Installing Starter Adapter.
2. Place the stator leads within the clamp and close
the loop. See Figure 11-65.
Figure 11-65. Routing Stator Leads through Clamp
on Adapter.
3. If the violet B+ charge lead is separate from the
main harness, secure it to the wiring harness
with a tie strap, directly above the clamp. See
Figure 11-66.
Figure 11-66. Side View of Stator and B+ Leads
Tied to Clamp on Adapter.
Install Flywheel
WARNING: Damaging Crankshaft and
Flywheel Can Cause Personal Injury!
Using improper procedures to install the flywheel can crack or
damage the crankshaft and/or flywheel. This not only causes
extensive engine damage, but can also cause personal injury,
since broken fragments could be thrown from the engine.
Always observe and use the following precautions and
procedures when installing the flywheel.
Section 11
Reassembly
11
11.19