Table of Contents
Advertisement
Jumper Settings and Connectors
3.4
CONNECTORS OF MAINBOARD
3.4.1 J1 - RESET SWITCH CONNECTOR
Attach the Reset switch cable to this connector. The Reset switch restarts
the system.
3.4.2 J2 - SUSPEND LED CONNECTOR
J2 is usually connected to a LED on front of the system case. If the system
board select is in suspend mode, the LED will be off.
3.4.3 J3 - SMI SWITCH
J3 is for SMI Break Switch Setting. When J3 is trigger from OPEN to
CLOSE and back to OPEN, the system would suspend immediately.
23
Advertisement
Table of Contents
