J10, J11 - Primary/Secondary Ide Connectors; J14 - Floppy Drive Connector; J20 - Serial Port Com2 Connector; Ps/2 Keyboard Connector - DTK PRM-0075I User Manual

High performance pentium pci atx mainboard

Table of Contents

3.9

J10, J11 - PRIMARY/SECONDARY IDE

CONNECTORS

J11 is the Primary IDE Connector and J10 is the Secondary IDE Connector. These

connectors support the provided IDE hard disk ribbon cable. After connecting the

single end to the board, connect the two plugs on the other end to your hard disk.

This connector supports the floppy drive ribbon cable. After connecting the single

end to the board, connect the two plugs on the other end to the floppy drive.

This connector supports the attached serial port ribbon cable (without mounting

bracket) to give a D-Type 9 pin male connector for connecting external serial

devices.

This connector is a six-pin female mini DIN connector using a PS/2 plug. If a

standard AT size keyboard plugs, you may use the DIN to mini DIN adaptor.

Fig. 19 Connectors

Connector Configuration

Table of Contents