Introduction; The 3-D/Tone Controller Controls; The 3-D/Tone Controller Display; Using The Spatial Control - DTK PAM-0050S User Manual

High performance pentium pci mainboard

Table of Contents

4.4.4.1 INTRODUCTION

For GOI-600D/DW Audio Extension Card, Spatializer hardware (ES938) is

provided that you can enjoy 3-D stereo effects and tone control. The 3-

D/Tone Controller has the Spatial Control and the Tone Controls. By

turning on the Spatial Control, any sound played through the AudioRack32

is transmitted in a wider arc, creating an atmosphere of a resonant sound

environment rather than audio issuing from a two dimensional plane. The

Tone Controls are used to boost or reduce the low end and high end of the

sound spectrum respectively giving you fuller sound.

Controls the amount of

spatialization from off

to minimum level to

mid level to maximum

level

Shows the amount of spatialization by the number of speakers that

are illuminated. If you set the Spatial Control to max, all the

speakers are blinking.

Shows the amount of boosting or reduction of the Bass or Treble.

The higher up the column past the mid point the light is lit, the more

boosting of the given tone control; Bass or Treble. The farther

below the mid point the light is, the greater the reduction of the

given tone control; Bass or Treble 3-D/Tone.

Enables and disables the Bass or

Trebble Control. There is one

Toggle button for each.

Controls the amount of boosting or

reduction of the Bass or Treble.

There is one slider for each.

Chapter 4

Table of Contents