Cn5 - Atx Power Supply Connector; Fan1 - Cpu Fan Connector; Ide0, Ide1 - Primary/Secondary Ide Connectors; Floppy - Floppy Drive Controller - DTK PAM-0079V User Manual

3.12 CN5 - ATX POWER SUPPLY CONNECTOR

3.13 FAN1 – CPU FAN CONNECTOR
FAN1 is a three-pin connector, which is used to connect with the CPU Fan Power
cable.
3.14 IDE0, IDE1 – PRIMARY/SECONDARY IDE
CONNECTORS
These connectors support the provided IDE hard disk ribbon cable.
connecting the single end to the board, connect the two plugs on the other end to
your hard disk or other device.

3.15 FLOPPY - FLOPPY DRIVE CONTROLLER

This connector supports the floppy drive ribbon cable. After connecting the single
end to the board, connect the two plugs on the other end to the floppy drive.
Fig. 14 ATX Power Supply Connector
Connector Configuration
After
21