3.3
J11 - ATX POWER CONNECTOR
J16 is a 2x10 pin male header connector. Plug the power connector of the ATX
power supply onto the connector.
3.4
J9 - FLOPPY DRIVE CONNECTOR
This connector supports the floppy drive ribbon cable. After connecting the single
end to the board, connect the two plugs on the other end to the floppy drive.
3.5
J6, J7 - PRIMARY/SECONDARY IDE
CONNECTORS
These connectors support the provided IDE hard disk ribbon cable.
connecting the single end to the board, connect the two plugs on the other end to
your hard disk.
Fig. 10 ATX Power Connector
Connector Configuration
After
21