DTK PAM-0050S User Manual page 125

Award BIOS Setup Guide 117
Onboard Serial Port 2: Available options are "Auto", "COM3/3E8",
"COM4/2E8", "COM2/2F8" and "Disabled". It is used to configure the on board
serial port 1 to different port address or disable it. Make proper selection to avoid
address conflict with other I/O devices.
UART 2 Mode: It is used to select the operating mode of on board serial port 2.
Choose Standard for RS232 serial Interface; ASKIR and HIPSIR for IrDA serial
Interface.
IR Function Duplex: This item will be shown only when UART 2 Mode is
selected to ASKIR or HPSIR. The available options are "Full" and "Half". It is used
to choose the IR function working in full duplex mode or half duplex mode
correspondingly.
RxD, TxD Active: This item will be shown only when UART 2 Mode is selected to
ASKIR or HPSIR. The available options are "Hi, Hi", "Hi, Lo", "Lo, Hi" and "Lo,
Lo". It is used to configure the logic level of Receive and Transmit signal in IrDA
interface.
Onboard Parallel Port: Available options are "3BCH/IRQ7", "278/IRQ5",
"378H/IRQ7" and "Disabled". It is used to configure the on board parallel port to
different port address and IRQ or disable it. Make proper selection to avoid address
and IRQ conflict with other I/O devices.
Onboard Parallel Mode: Available options are "SPP", "EPP/SPP", "ECP" and
"ECP/EPP". It is used to configure the on board parallel port to "Standard Printer
Port Mode", "Enable Parallel Mode" or "Extended Capabilities Port Mode. Make
proper selection with the attached printer port device.
ECP Mode Use DMA: Choose "1" or "3" to select the DMA channel used for the
ECP device. This item is shown if the Onboard Parallel Mode is chosen as "ECP"
or "ECP/EPP" option.
Parallel Port EPP Type: Choose "EPP1.7" or "EPP1.9", which is used to
configure the EPP using either EPP1.7 or 1.9 timing specification. This item is
shown if the Parallel Mode is chosen as "EPP" or "ECP/EPP" option.