Jp11, Jp12 - Primary/Secondary Ide Connectors; Jp13 - Hdd Led; Jp14 - Power On/Off Switch; Jp15 - Power Led - DTK PRM-0080I ZX User Manual

3.4 JP11, JP12 - PRIMARY/SECONDARY IDE
CONNECTORS
These connectors support the provided IDE hard disk ribbon cable.
connecting the single end to the board, connect the two plugs on the other end to
your hard disk or other device.
3.5

JP13 - HDD LED

JP13 is usually connected to a HDD LED on front of the system case. If the HDD is
in operation, the indicator lights during operation.
3.6

JP14 - POWER ON/OFF SWITCH

It is used to switch on or off the ATX power supply. The power is turned on by
short the power switch once. It needs to hold the power switch about 4 seconds to
turn it off when it has not start to display.
3.7

JP15 - POWER LED

Attach the power led cable to this connector. If the system is power on, the indicator
lights.
3.8

JP16 - RESET

Attach the Reset switch cable to this connector. The Reset switch restarts the
system.
Fig. 6 HDD LED
Fig. 7 Power LED
Connector Configuration
After
9