Table of Contents
Advertisement
116
Chapter 5
A short description of the screen items follows:
Internal PCI/IDE: Available selection are "Disabled", "Primary", "Secondary",
"Both".
It is used to configure the built in PCI IDE controller.
"Disabled" will disable the internal PCI IDE controller.
"Primary" will configure the internal PCI IDE controller to enable the primary
channel only.
"Secondary" will configure the internal PCI IDE controller to enable the secondary
channel only.
"Both" will configure the internal PCI IDE controller to enable both the primary and
secondary channels.
IDE Primary Master PIO/IDE Primary Slave PIO/IDE Secondary Master
PIO/IDE Secondary Slave PIO: Available selection are "Auto", "Mode 0", "Mode
1", "Mode 2", "Mode 3" and "Mode 4". To choose "Auto", the system BIOS will scan
the IDE device and decide which mode of the device is. Otherwise the user should
key in the mode of the device to the corresponding field.
Primary IDE Prefetch/Secondary IDE Prefetch: It is used to enable or disable
the prefetch buffer of the corresponding IDE channel.
IDE Burst Mode: It is used to enable or disable the IDE burst mode.
IDE Post Write: It is used to enabled or disabled the IDE post write buffer.
IDE HDD Block Mode: It is used to enable or disable the IDE harddisk block
mode.
Onboard FDD Controller: It is used to enable or disable the on board floppy disk
controller.
Onboard Serial Port 1: Available options are "Auto", "COM4/2E8",
"COM3/3E8", "COM1/3F8" and "Disabled". It is used to configure the on board
serial port 1 to different port address or disable it. Make proper selection to avoid
address conflict with other I/O devices.
Advertisement
Table of Contents
