Jp10 - Floppy Drive Controller; Jp11, Jp12 - Secondary/Primary Ide Connectors; Jp13 - Hdd Led; Jp14 - Power On/Off Switch - DTK PRM-0076I Manual

3.4

JP10 - FLOPPY DRIVE CONTROLLER

This connector supports the floppy drive ribbon cable. After connecting the single
end to the board, connect the two plugs on the other end to the floppy drive.
3.5 JP11, JP12 – SECONDARY/PRIMARY IDE
CONNECTORS
These connectors support the provided IDE hard disk ribbon cable.
connecting the single end to the board, connect the two plugs on the other end to
your hard disk or other device.
3.6

JP13 - HDD LED

JP13 is usually connected to a HDD LED on front of the system case. If the HDD is
in operation, the indicator lights during operation.
3.7

JP14 - POWER ON/OFF SWITCH

It is used to switch on or off the ATX power supply. The power is turned on by
short the power switch once. It needs to hold the power switch about 4 seconds to
turn it off when it has not start to display.
Fig. 7 HDD LED
Connector Configuration
After
13