Testing Demand Response - Eaton WaveLinx User And Programming Manual

WaveLinx User Manual
Step 4: Use the DR reduction controls to enter the desired amount of reduction. Drag and drop zones between the controlled zones section
and the exempt zones section to change the loads that respond (Only dimmable zones will respond to demand response signals).

Testing Demand Response

The WaveLinx Mobile Application contains a built-in test feature for verifying that demand response levels are set correctly. When activated,
all areas with zones assigned to respond to demand response will respond with the defined reductions.
To test demand response:
Step 1: Open the WaveLinx Mobile Application and establish a connection with the Wireless Area Controller as the administrator user.
Step 2: In the areas list, select ANY area.
Step 2: In the areas list, select ANY area.
Adjust percentage of light level
reduction when the demand
response signal is received
Touch and drag zones between the
controlled zones and exempt zones
to the demand response signal
www.eaton.com/wavelinx
97