Modifying Closed Loop Daylighting Control - Eaton WaveLinx User And Programming Manual

Modifying Closed Loop Daylighting Control

This section focusses on the use of closed loop sensor control. This includes details on how to:
Disabling daylighting for closed loop sensors
•
Calibrate closed loop sensors located in interior spaces
•
Calibrate closed loop sensors located in exterior spaces
•
Disabling Daylighting for Closed Loop Sensors (Interior and Exterior Sensors)
The automatic code commissioning operation causes standard ambient, industrial and outdoor fixture integrated sensors as well as tilemount
sensors to begin daylight dimming as soon as the device is assigned to an area. If the devices are located in areas that should not daylight
dim, disable the daylight set to avoid nuisance dimming if the electric light reflectance alone exceeds the expected target level.
Step 1: Open the WaveLinx Mobile Application and establish a connection with the Wireless Area Controller as the administrator user.
Step 2: In the areas list, select the area that contains the controlled fixture.
72
www.eaton.com/wavelinx
WaveLinx User Manual