Using The Mobile Application To Pair Devices - Eaton WaveLinx User And Programming Manual

WaveLinx Tilemounted Sensor
WaveLinx Ceiling Sensor
WaveLinx Wireless Outdoor Lighting Control Module
WaveLinx Wallstation standard line voltage powered
WaveLinx Battery Powered Wallstation
WaveLinx Receptacle
7: Repeat the procedures in this section for each Wireless Area Controller in the facility.

Using the Mobile Application to Pair Devices

The WaveLinx Mobile Application may be used in the pairing process as an alternative to pressing the PAIR button on the Wireless Area
Controller. Log in as the administrator user and open the menu to select the option to discover new devices, acknowledging the message
that appears. A pairing icon will appear at the top of the screen to indicate that they system is in pairing mode. Once pairing is complete,
access the menu and select the option to stop discovering devices to end pairing mode or allow it to time out automatically.
Pairing Active icon
Enable pairing
16
www.eaton.com/wavelinx
Paired device behavior:
Connected 0-10V dimmable fixtures dim to 10%.
LED in sensor window should blink WHITE with motion
detection.
Not applicable for this device.
Paired device behavior:
Fixture dims to 10%.
Paired device behavior:
All button LEDs will flash in a top to bottom the
bottom to top pattern until pairing mode is exited.
Paired device behavior:
There is no immediate feedback that pairing was
successful. Refer to method 2.
Paired device behavior:
All paired receptacles still in the default construction
area will turn OFF for 5 minutes. After 5 minutes, the
receptacles will turn back ON. If there are too many
receptacles to review in the 5 minute period, see
alternate method 2.
Acknowledge
Not applicable for this device.
Ensure that the Wireless Area Controller is not
in pairing mode. Then, press any button on the
wallstation. All lighting and receptacles paired with
the Wireless Area Controller and still in the default
construction area will respond to the command.
Ensure that the Wireless Area Controller is not in
pairing mode. Then, press the manual push button on
the receptacle (1 second press) to toggle the controlled
outlet. A successfully paired receptacle still in the
default construction area will flash its LED either
between red/OFF, or green/amber for a period of
approximately 15 seconds.
Cancel pairing
WaveLinx User Manual
Acknowledge