Table of Contents
Advertisement
WaveLinx User Manual
Bringing the System Online
The WaveLinx Wireless Connected Lighting System configures quickly to allow immediate energy savings. Use the steps in this section to:
• Step 1: Confirm that installed devices are ready for configuration
• Step 2: Complete initial construction grouping to prepare for mobile application use
• Step 3: Initiate communications with the WaveLinx Mobile Application
• Step 4: Organize devices into controlled areas and zones for automatic code commissioning operation
Step 1: Confirming Device Installation
Before configuring devices, ensure that they are ready by verifying installed operation.
Device
Wireless Area Controller
Eaton LED
WaveLinx Wireless Dimming Switchpack
(WSP-MV-010: 120-277VAC model)
WaveLinx Wireless Dimming Switchpack
(WSP-CA-010: 120-347VAC model)
WaveLinx Integrated Sensor
(including standard and Bluetooth enabled models)
WaveLinx Industrial Integrated Sensor
Default LED Functionality
After a 1 minute power up period:
• EATON logo LED: Blue LED should illuminate the
WAN LED
Eaton logo and remain ON.
LAN LED
• 802.15.4 LED: Blue LED should illuminate and
remain ON.
Wi-Fi LED
Note: The green LAN LED may also be illuminated if
not used
the controller is connected to a building LAN with a
DHCP server. Other LEDs should be OFF.
802.15.4 LED
The white LED on this wireless Dimming Switchpack
model illuminates to indicate the load is ON. If the
onboard commissioning push button is pressed for less
than 4 seconds, the LED and attached load will toggle
state.
Not applicable. This wireless Dimming Switchpack
model has no onboard LED indicators.
LED in sensor window should blink green with motion
detection. The green LED color indicates that the
integrated sensor has not yet been paired with a
Wireless Area Controller.
(If the LED blinks white, this indicates that the sensor
has been previously paired with a Wireless Area
Controller. See page 135 for information on resetting
the pairing.)
LED in sensor window should blink green with motion
detection. The green LED color indicates that the
integrated sensor has not yet been paired with a
Wireless Area Controller.
(If the LED blinks white, this indicates that the sensor
has been previously paired with a Wireless Area
Controller. See page 135 for information on resetting
the pairing.)
Operational Functionality Out-of-the-Box
Not Applicable for this device.
• Connected loads will turn ON and 0-10V dimmable
loads will go to 75% once power is applied.
• Load remains ON at 75% unless commissioning
push button is used for manual override.
Connected loads will turn ON and remain ON with
dimmable loads at a 100% level.
Fixture operates via the onboard occupancy sensor.
• Occupancy turns fixture ON to 75%.
• Fixture will turn OFF within 20 minutes
when space is vacant.
Note: Daylighting is disabled until the fixture is
assigned to an area using the WaveLinx Mobile
Application.
Fixture operates via the onboard occupancy sensor.
• Occupancy turns fixture ON to 100%
• Fixture will dim to 10% within 20
Note: Daylighting is disabled until the fixture is
assigned to an area using the WaveLinx Mobile
Application.
www.eaton.com/wavelinx
9
Advertisement
Table of Contents
