Analog Input (Ai) Function Block - Emerson Rosemount 3051CF Series Reference Manual

Reference Manual
00809-0100-4774
2.8

Analog input (AI) function block

2.8.1 Configure the AI block
Note
Always check and reconcile function block configuration (with the exception of resource
and transducer blocks) after commissioning the transmitter to the control host. You may
not save function block configuration, including AI blocks, made prior to device
commissioning in the control host to the control host database during the commissioning
process. In addition, the control host may download configuration changes to the
transmitter as part of the commissioning process.
Note
Typically, you make changes to the AI block configuration after the transmitter is
commissioned using the control host configuraiton software. Consult your host system
documentation to see if the AI block guided configuration method provided in the DD or
DTM should be used after the device has been commissioned.
Note
DeltaV
changes using the DeltaV Explorer.
A minimum of four parameters are required to configure the AI block. The parameters are
described below with example configurations shown at the end of this section.
AI block configuration edits
Note
Always check and reconcile function block configuration (with the exception of resource
and transducer blocks) after commissioning the transmitter to the control host. You may
not save function block configuration, including AI blocks, made prior to device
commissioning to the control host to the database during the commissioning process. In
addition, the control host may download configuration changes to the transmitter as part
of the commissioning process.
Note
Typically, make changes to AI block configuration after the transmitter is commissioned
using the control host configuration software. Consult your host system documentation
to see if the AI Block guided configuration method provided in the DD or DTM should be
used after the device has been commissioned.
Note
For DeltaV users, only make final AI block configuration and AI block configuration
changes using the DeltaV Explorer.
A minimum of four parameters are required to configure the AI Block. The parameters are
described below with example configurations shown at the end of this section.
Reference Manual
™
users should only make final AI block configuration and AI block configuration
Configuration
July 2020
39