Table of Contents
Advertisement
If already selected, deselect and reselect Convergence Enable.
11. To reset the electronic convergence, select Reset.
12. At the confirmation prompt, select Reset and then apply and store the new settings using step
10.
Running Auto Setup to optimize display settings
Auto Setup initiates an automated process in which the projector optimizes video settings for the
active signal. Auto Setup helps to save time in perfecting a display and you can modify the
adjustments as required.
1. Make sure of the following before running Auto Setup:
•
Test patterns are turned off (on page 37).
•
The active signal is valid.
2. From the remote, select Auto Signal or from the web UI, select Auto Setup.
3. Select Run Auto Setup.
The system optimizes the active signal and displays a progress message on screen.
Disposing of the product packaging
Once the product has been installed and set up, Christie recommends reusing or recycling the product
packaging according to your local regulations.
Completing the installation checklist
Complete the provided installation checklist (P/N: 020-103137-XX) and return it to Christie.
Christie Griffyn Series Installation and Setup Guide
020-103314-08 Rev. 1 (06-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installation and setup
49
Advertisement
Table of Contents
