Running Auto Setup To Optimize Display Settings; Selecting A Test Pattern - Christie Boxer 30 Installation And Setup Manual

Hide thumbs Also See for Boxer 30:

Table of Contents

2. Select ZOOM.

3. Use the up and down arrows to zoom in or out of the image.

4. To exit, select Back.

5. Select FOCUS.

6. Use the up and down arrows to adjust the focus of the image.

7. To exit, select Back.

8. To refine your adjusts, repeat steps 2 to 7.

Running Auto Setup to optimize display settings

Auto Setup initiates an automated process in which the projector optimizes video settings for the

active signal. Auto Setup helps to save time in perfecting a display and you can modify the

adjustments as required.

1. Make sure of the following before running Auto Setup:

•

Test patterns are turned off (on page 29).

•

The active signal is valid.

2. From the remote, select Auto Signal.

From the web UI, select Auto Setup.

3. Select Run Auto Setup.

4. Select the resolution for your projector.

The recommended option for your setup is selected by default.

5. Select Apply.

6. At the confirmation prompt, select Keep.

21 test patterns are available to assist with the configuration of the projector and to diagnose any

issues that may occur.

1. From the side panel home page, use the arrows to select Test Pattern.

You can also select the test patterns from MENU > Test Pattern.

2. Scroll through the list of test patterns.

3. Select the required test pattern.

4. To confirm your selection, select Enter.

Boxer 30 Installation and Setup Manual

020-102017-01 Rev. 1 (11-2015)

Installation and setup

Table of Contents