Table of Contents
Advertisement
Standard Cleaning
μ
ATTENTION! For cleaning between spray jobs, where crops are not very sensitive towards chemicals just sprayed.
1. Engage the pump with tractor in idle, so that pump speed is as low as possible (approx. 250-280 or 550-580 RPM,
depending on pump type).
2. Press
to enable suction from the RinseTank and press
RinseTank content into the main tank.
It is important to have full agitation for approximately 20 seconds; and then close the agitation completely.
3. Press
to enable suction from MainTank and press
seconds.
4. Switch all boom sections ON. Spray until air comes out of nozzles. Engage FlexCapacity pump.
When the pressure drops, close the regulation valve by pressing the
yellow LED lights on the valve (this can take up to 10 seconds). For location of the DynamicFluid4
regulation valve, see "Right Side Cover" on page 69.
When the boom is completely empty, press the
spike.
Press "auto" to have the system remove pressure spikes automatically before next start-up.
Repeat the Following Three Steps 5 Times:
5. Press
to enable suction from the RinseTank and press
RinseTank content into the main tank.
6. Press
to enable suction from MainTank and press
seconds.
7. Switch all boom sections ON. Spray until air comes out of nozzles. Engage the FlexCapacity pump, if available.
When the pressure drops, close the regulation valve by pressing the
yellow LED lights on the valve (this can take up to 10 seconds).
When the boom is completely empty, press the
spike.
Press "auto" to have the system remove pressure spikes automatically before next start-up.
Use of Cleaning Agents
Recommended is to use an appropriate cleaning agent suitable for cleaning agricultural sprayers.
• Recommended is cleaning agents containing a suitable lube or conditioner.
• If for some reasons not available, and instead using triple ammonia water, it is important to rinse the liquid system
immediately after, and add some lubricant to the rinsing water to prevent ball valves etc. seizing up.
• Use of automotive antifreeze/radiator coolant (ethylene glycol) will protect valves and seals from drying or seizing up.
while transferring approximately 1/6 of the
with all boom sections OFF for approximately 45
button on the SetBox, until
button for a few seconds to avoid a pressure
while transferring approximately 1/6 of the
with all boom sections OFF for approximately 45
button on the SetBox, until
button for a few seconds to avoid a pressure
5 - Operation
131
Advertisement
Table of Contents
