Table of Contents
Advertisement
5 - Operating
Cleaning
Technical Information
In order for your mist blower to last for many years, it is recommended you follow a maintenance programme. As
part of this maintenance it would be necessary to include a thorough cleaning.
To do this, your equipment should include a cleaning kit made up of a rinse tank and a multi-hole rotary nozzle inside
the tank.
The tank is made of yellow polyethylene and its capacity is 10%
that of the main tank, therefore 40 litres for a 400-litre tank, 60 for
A
a 600-litre tank and 100 for a 1,000-litre one.
It is to be found on the lower left-hand side of the chassis and is
totally independent from the main tank.
The lid
A
is on the left-hand side of the equipment and is easy to
find because it is red. On the lid there is a tie which attaches it to
the tank so that it does not get lost.
You should fill this tank up with a hose that does not belong to
the equipment's liquid circuit, so as to avoid any sort of chemical
product getting inside this tank.
To clean the tank, you should place the three-way valve situated
above the suction filter in the clean water tank position.
The multi-hole rotary nozzle is inside the main tank.
The pressure that gets to this nozzle makes the head go round
at high speed, thus the clean water comes out as dozens of jets
that clean every nook and cranny of the tank.
To activate this multi-hole rotary nozzle for internal cleaning you
should turn the tap situated on the pressure collector.
5.7
Advertisement
Table of Contents
