Table of Contents
Advertisement
Installation of Control Unit Brackets
Find a suitable place in the tractor cabin to fit the control units.
Best recommended position is to the right of the driver seat.
The supplied tractor pillar bracket (A) has a hole spacing of 100 and 120
mm, which fits most tractors. Threaded holes for fitting may be hidden
behind the front corner cover. Check the tractor's instruction book for
information regarding attachment points.
Supplied are three tubes (B) for fitting. One, two or all three may be used.
They can be bent and shortened. A spacer (C) is also supplied to allow
further attachment possibilities. Find the best solution for your tractor or
vehicle.
The tube (B) plate is staggered so that, if correctly orientated, all boxes
will line up.
μ
ATTENTION! See also the controllers instruction book for further
details of fitting the controller equipment.
4 - Sprayer Setup
C
A
100 -120mm
B
85
Advertisement
Table of Contents
