Hardi AEON CENTURA DELTA FORCE Instruction Book page 121

Table of Contents

Advertisement

4. After entering the quantity, the screen will
show the MainTank contents wanted after
the filling procedure has ended (A).
5. Engage the pump and set PTO revolutions at
max. 540 RPM or 1000 RPM depending on
pump model.
6. Press
to AutoFill the MainTank. This
set the fluid valves for their correct positions
and start the filling process.
DANGER! Before pressing
important to ensure that the PressureEmpty
quick coupler lid
completely fitted to the filling coupler into
its locked position. Failure to do so may cause risk of contamination and injury from the PressureEmpty quick coupler
lid being "shot" off when pressurized! If not possible to fit the quick coupler lid completely, lubricate the rubber seal
and the grip hooks.
7. Keep an eye on the top window (B) in the display for filling status.
8. Fill the MainTank at least 1/2 with water (unless otherwise stated on the chemical container label).
±
WARNING! Do not leave the sprayer while filling the tank. Keep an eye on the top window (B) in the display for filling
status.
9. Press
to leave the AutoFill menu.
10. Press
to enter the agitation menu.
11. Set the agitation valve as required:
100
A fully open agitation valve will result in very little suction capacity from the TurboFiller.
%
Preferred when agitation is necessary for mixing very dense chemicals, while transferring from the
75
%
TurboFiller.
50
%
Preferred when agitation is necessary for mixing, while transferring chemicals from the TurboFiller.
Preferred when transferring the powder into the tank requires more suction from the TurboFiller, but
25
%
mixing does not require much agitation.
A fully closed agitation valve will result in no agitation, while transferring the powder into the tank,
OFF
resulting in poor mixing.
μ
ATTENTION! Changing the suction restrictor for the TurboFiller, may be necessary for increased suction capacity from
the TurboFiller. Contact your HARDI dealer for further advice.
12. Open the TurboFiller lid.
13. Open the TurboDeflector valve.
, it is very
is correct and
5 - Operation
121

Advertisement

Table of Contents
loading

Table of Contents