Standard Cleaning - Hardi COMMANDER DELTA FORCE Instruction Book

Standard Cleaning

μ
ATTENTION! For cleaning between spray jobs, where crops are not very sensitive towards chemicals just sprayed.
1. Engage the pump with tractor in idle, so that pump speed is as low as possible (approx. 250/550 rpm, depending on
pump type).
2. Turn the suction valve towards
while transferring approximately 1/6 of the RinseTank content into the main tank.
It is important to have full agitation for approximately 20 seconds; and then close the agitation valve completely.
3. Turn the suction valve towards
with all boom sections OFF for approximately 45 seconds.
Switch all boom sections ON. Spray until air comes out of nozzles. When the pressure drops, close the regulation valve by
pressing the button, until yellow LED lights on the valve. When the boom is completely empty, press the
a few seconds to avoid a pressure spike.
Repeat the Following Three Steps 5 Times:
4. Turn the suction valve towards
while transferring approximately 1/6 of the RinseTank content into the main tank.
5. Turn the suction valve towards
with all sections off for approximately 45 seconds.
6. Turn all sections on. Spray until air comes out of nozzles. When the pressure drops, close the regulation valve by
pressing the button, until yellow LED lights on the valve.When the boom is completely empty, press the
for a few seconds to avoid a pressure spike.
and the pressure valve towards
and the pressure valve towards
and the pressure valve towards
and the pressure valve towards
5 - Operation
button for
button
117