Intermec EasyCoder PF4i User Manual page 93

Chapter 8 — Troubleshooting
78
Printout Missing Along Inner Edge
Possible Cause
Bad media alignment
Using small core with supply
post in upper position.
X-start parameter value too low Increase value
Transfer Ribbon Breaks
Possible Cause
Ribbon not fitted correctly
Wrong media grade
Bad energy control
Transfer Ribbon Wrinkles
Possible Cause
Faulty ribbon break shaft adjustment Adjust shaft.
Incorrect edge guide adjustment
Printhead pressure too strong
No Thermal Transfer Printout
Possible Cause
Ink-coated side of ribbon is not facing
media
Media Feed Not Working Properly
Possible Cause
Changed media characteristics
Wrong label rest dots parameter Check/change
Wrong Media Type parameter
Wrong LSS position
Remedy
Adjust media alignment Chapter 3
Move post to lower
position
Remedy
Reload ribbon correctly Chapter 4
Change parameter, then
clean printhead
Adjust
Remedy
Adjust edge guide Chapter 3
Adjust pressure
Remedy
Reload ribbon Chapter 4
Remedy
Press the Print button Chapter 3
Check/change
Check/change
EasyCoder PF4i User's Guide (IPL Version)
Reference
Chapter 2
Chapter 5
Reference
Chapter 5,
Chapter 9
Call Service
Reference
Chapter 10
Chapter 10
Reference
Reference
Chapter 5
Chapter 5
Chapter 10