Label Taken Sensor; Thick Media Printhead; Interface Boards - Intermec EasyCoder PF4i User Manual

Label Taken Sensor

Thick Media Printhead

Interface Boards

EasyCoder PF4i User's Guide (IPL Version)
The adapter is pressed onto the media supply hub and held in
place by a screw. When fitting the adapters, make sure that the
screw hits a rounded plastic surface, not a metal leaf spring. Not
used with a media supply roll post.
The Label Taken Sensor (LTS) is a photoelectric sensor fitted to
the center section inside the front door. It allows the printer's
firmware to detect if the latest printed label, ticket, or tag has
been removed before printing another copy.
The label taken sensor is usually factory-fitted, but is also
available as a kit for installation by an authorized service
technician. It cannot be fitted in combination with a paper
cutter.
In addition to the standard printhead, which is designed for a
maximum media thickness of 175 μm (7 mils) there is an
optional printhead for thick media (170 to 220μm/6.6 to 8.7
mils). The printhead can easily be replaced or exchanged by the
operator as described in Chapter 9,
A number of interface boards are available for use with the
EasyCoder PF4i printer. The interface boards are either factory-
fitted or can easily be fitted by an authorized service technician.
The EasyCoder PF4i printer can accommodate one EasyLAN
interface board plus one other interface board.
EasyLAN boards:
• EasyLAN Ethernet interface
• EasyLAN Wireless interface
Other communication boards:
• Parallel Interface Board (IEEE 1284)
Chapter 7 — Options
"Maintenance" on page 81.
71