GE Concord 4 Installation Manual page 93

Outputs
Shortcut: 065xnn where
nn is schedule number
and x is output number
minus 1
Default: Off
Arming
Shortcut: 0660nn where
nn is schedule number
Default: Off
Concord 4 Installation Manual
This setting lets you attach outputs to a time schedule. Onboard outputs are
1 to 2; SnapCard outputs are 3 to 6.
Only onboard and SnapCard outputs can be scheduled. These outputs can
only be scheduled if output text has been entered in installer programming
and if the output is assigned to the same partition as the touchpad used.
To attach schedules to outputs:
1. Press A or B until the display shows ATTACH SCHEDULES TO EVENTS.
2. Press # then A or B until the display shows OUTPUTS. Press # to enter the
Outputs menu.
3. Press A or B until the output appears.
4. Press # and the display shows SCHEDULE 00 OFF/ON (current
setting). If you want a different schedule, press A or B until the schedule
appears.
5. Press 1 (off) or 2 (on). The display flashes the entered selection. Press #
and the display shows the new setting for the selected schedule. Repeat the
process until all desired outputs are attached to schedules.
This setting lets you arm according to a time schedule. This setting will allow
you to arm to away only. There is no disarm schedule.
To attach schedules to arming:
1. Press A or B until the display shows ATTACH SCHEDULES TO EVENTS.
2. Press # then A or B until the display shows ARMING.
3. To select arm to Away press #.
4. Press # and the display shows SCHEDULE 00 OFF/ON (current
setting). If you want a different schedule, press A or B until the schedule
appears.
5. Press 1 (off) or 2 (on). The display flashes the entered selection. Press #
and the display shows the new setting for the selected schedule.
6. Repeat the process until all desired schedules are attached.
Chapter 3: Programming
87