GE Concord 4 Installation Manual page 72

Chapter 3: Programming
Sensor text
Shortcut: 081
Default: None
Delete sensors
Shortcut: 082
Default: None
66
Use the following guidelines to name zone and sensor locations:
• Use the item numbers that appear in Table 25 on page 128 for characters
and words listed there.
• If a desired word does not appear in the table create it using the
characters (custom text).
• When using words from the table, spaces between them appear
automatically. When using characters from the table to create words, you
must reserve an item number for a 'space' after the word.
• Each character or word uses one item number. For example, a word from
the list counts as one item number.
• Only 16 item numbers are allowed for each zone or sensor name, so plan
before programming sensor text. You may need to abbreviate words to
avoid running out of item numbers.
To program sensor text:
1. Press A or B until the display shows SENSOR TEXT.
2. Press # and the display shows TEXT FOR SN 01.
3. Press A or B until the display shows the desired sensor number (or enter
the desired sensor number and press #).
4. Press # and the display shows: SN 1 ITEM 0 0 - ________. Where
ITEM 0 is the first character/word location and 0 is the character/word
number.
5. Enter the number of the character or word, or scroll through the numbers
by pressing B (forward) or A (backward). If you make a mistake, enter the
correct number or continue scrolling through choices.
6. Press # to accept the displayed choice and the display shows:
SN 1 ITEM 1 0 -.
7. Repeat the process as needed to complete the zone or sensor name.
8. Press * after entering the last character or word number. The display
shows the complete text name. For example: TEXT FOR SN 01 FRONT
ENTRY DOOR.
Note: Deleting sensors do not delete sensor text associated with the deleted
sensor number. To delete sensor text, enter the sensor text setting and
enter 000 (nulls) for each item number.
To remove hardwired zone and wireless sensor numbers from panel
memory:
1. Press A or B until the display shows DELETE SENSORS.
2. Press # and the display shows DELETE SENSOR nn (lowest
zone/sensor number in panel memory).
3. Press # to delete the displayed sensor or, enter the desired sensor
number, then press #.
4. Repeat the process until all desired sensors are deleted.
Concord 4 Installation Manual