Connecting To Token-Ring Telemetry Networks - Agilent Technologies J3919A Installation & User Manual

Installation
Connecting the Probe
Figure 3-5: Connecting the Probe to a 10Base-T/100Base-T Network

Connecting to Token-Ring Telemetry Networks

The Token-Ring option must be installed to connect the probe to a Token-Ring
telemetry network.
CAUTION
Connecting the Token-Ring interface to your network when the interface is
configured to the wrong network speed (4Mb/16Mb) can cause disruption of all
traffic on your network and it will prevent the probe from properly inserting into
the ring.
You can configure the Token-Ring Speed from the Modify/View Configuration
Values Menu. The probe is configured with a default setting for 16Mbps
networks.
You connect the Token-Ring interface to your network by using the appropriate
cables. The probe has both RJ-45 and DB-9 connectors on the rear panel for
connecting to Token-Ring networks. Figure 3-3 on page 51 shows the back panel
with the Token-Ring option installed.
54