Agilent Technologies J3919A Installation & User Manual page 51

NOTE
If the Token-Ring telemetry interface is installed, you can configure either the
Fast Ethernet interface or the Token-Ring interface as the telemetry interface. The
Fast Ethernet interface comes from the factory configured as Telemetry and the
Token-Ring interface comes configured as Monitor/Transmit and is disabled.
"Disabled" in this case means that the interface does not function at all, not as a
Telemetry port nor as a Monitor/Transmit port. If you configure the Token-Ring
interface as Telemetry, the Fast Ethernet interface automatically becomes
configured as Monitor/Transmit and is disabled.
Port Type
IP Address
Default Gateway
IP Address
Subnet Mask
Token-Ring
Speed
Press 2 and select the port type as Telemetry. Making this
configuration change will disable the Ethernet telemetry port
(port 1). You can select either the Token-Ring or the Fast
Ethernet interface (but not both) as the telemetry port. The
telemetry port does not maintain network statistics for the
Token-Ring interface. The telemetry interface only allows the
retrieval of ATM network statistics. Refer to "Fast Ethernet
Telemetry Interface Configuration" on page 25 for
information on configuring the Fast Ethernet interface. The
probe must be configured with exactly one telemetry port.
Press 3 and enter the IP address for the probe. If the IP
address is 0.0.0.0, the probe will transmit Bootp Requests
for configuration information (including IP address) over the
network. This does not apply to ports configured as Monitor-
Only.
Press 4 and enter the default gateway IP address for the probe
(optional).
Press 5 and enter the subnet mask for the probe.
Press 6 to modify or view the network speed setting.
The default configuration is set to 16 Mbps network speed.
You can enter values of 4 or 16 for 4 Mbps or 16 Mbps
respectively or enter Auto to automatically sense the ring
speed.
Local Terminal Configuration
Using a Local Terminal
31