Connecting To 10Mb/S Ethernet Telemetry Networks - Agilent Technologies J3919A Installation & User Manual

Figure 3-3: The Probe's Rear Panel (Token-Ring Option Shown)

Connecting to 10MB/s Ethernet Telemetry Networks

You can connect the probe to the network either by connecting the RJ-45
connector to a 10Base-T/100Base-TX half-duplex network or by connecting the
AUI connector to a 10MB/s Ethernet network. Use the following procedures to
connect the probe's AUI connector to a 10MB/s Ethernet network for telemetry
communications. Never use both the AUI and RJ-45 connectors.
Agilent J3919A
Agilent J3972A
Installation
Connecting the Probe
51