Probe Memory Allocation - Agilent Technologies J3919A Installation & User Manual

Specifications

Probe Memory Allocation

The memory allocated to each parameter depends on how much memory is
installed in the probe. The memory parameter values relate to the various items in
the RMON or the Agilent private MIBs. These parameters were valid at the time
of publication.
Table B-2 on page 131 shows the memory allocated to each parameter for the
available probe memory configurations. The memory allocation shown for each
memory amount column assumes that all of the available memory within the
probe is allocated to the identified parameter.
NOTE
The parameter values shown in Table B-2 on page 131 are approximate and
subject to change without notice.
Network Statistics and Trace buffers (packet capture buffers) are allocated
dynamically from the same memory allocation. The values shown for Network
Statistics assume that no Trace buffers are configured. If Trace buffers are
configured, the number of Network Statistics are reduced.
130