Figure 2-8: Modify/View Interface Values Menu (Oc-3 Atm, Port) - Agilent Technologies J3919A Installation & User Manual

Local Terminal Configuration
Using a Local Terminal
Cell
Sychronization
Cell Scrambling
3. Press S to save the configuration changes and return to the probe's Main
Menu. If you want to cancel your current changes and return to the probe's
Main Menu, press 0 .
Use the following procedure to configure items in the Modify/View Interface
Values menu for the second port on the OC-3 ATM interface:
1. Press 3 to access the Modify/View interface values menu item. The
Modify/View Interface Values menu for port 2 is displayed, as shown in
Figure 2-8.
Modify/View Interface Values Menu - Firmware Rev
Interface Type
1. Port
2. Port Type
3. Network Type
S. Save changes and exit
0. Cancel changes and exit
Figure 2-8: Modify/View Interface Values Menu (OC-3 ATM, Port 2)
2. Select each field requiring configuration (one at a time) by pressing its
corresponding number and then entering the values that are appropriate for
your network.
Port
34
Cell Sychronization is configured as HEC (Header Error
Control).
Press 2 and then set Cell Scrambling to On or Off.
Press 1 and then enter the desired OC-3 ATM interface's port
number to display the OC-3 ATM port's configuration
parameters along with their current settings. Refer to
"Display Interface Summary" on page 36 for information on
port types and port numbers for the installed interfaces. You
ATM
3.1/ATM
Monitor-only
UNI