Modify/View Interface Values Menu - Firmware Rev
MAC Address
Interface Type
1. Port
2. Port Type
3. IP address
4. Default gateway IP address
5. Subnet mask
6. Physical Connector
7. Link Speed
S. Save changes and exit
0. Cancel changes and exit
NOTE
Local Terminal Configuration
Using a Local Terminal
Figure 2-5: Modify/View Interface Values Menu (Fast Ethernet)
2. Select each field requiring configuration (one at a time) by pressing its
corresponding number and then entering the values that are appropriate for
your network.
Refer to "Display Interface Summary" on page 36 for information on port types
and port numbers for the installed interfaces.
Port
26
Press 1 and then press 1 again to display the Ethernet port's
configuration parameters along with their current settings.
Port 1 is always the Ethernet telemetry interface (the
10Base-T/100Base-TX with RJ-45 and AUI connectors). You
can then view or configure the Ethernet port's configuration
parameters.
00 00 C6 XX XX XX
Ethernet
1.1/Ethernet
Telemetry
0.0.0.0
0.0.0.0
255.0.0.0
RJ-45
Auto Negotiate